My original thought was to make the gumballs in the machine a little 3-D with pop dots and leave them loose, but they kept flipping over in the shaker. So this turned out to be a mock shaker card as I ended up gluing them down.
Jillibean Soup Clear Stamps Sweet Treat
Jillibean Soup Small Circle Die Cut Shaker Card
Jillibean Soup Small Circle Shaped Shaker
pop dots; white cardstock; embossing heat tool; Versamark ink pad; Wendy Vecchi Embossing Powder in Red Geranium; Memento Dye Ink in Love Letter, Tangelo, Dandelion, Bamboo Leaves, Danube Blue, and Grape Jelly; masking paper or pen (having neither, I resorted to using Post-it notes); and a MISTI
Start with the Versamark and stamp the gumball machine and sentiment. Dust with embossing power and heat set. Mask the gumball machine with whichever method you choose, and use the various Memento Inks to stamp a gumball background. With the same inks, stamp some gumballs on white cardstock and fussy cut them out. Remove the masks from the gumball machine. Line up the gumballs with the opening in the front of the card and pop dot them to the back of the card. Add the shaker plastic and you're set!
I tried for colors as close to the given challenge colors as I could get, but I didn't quite make it. Clearly this means my crafting stash isn't big enough yet! ^_~ This particular card is full of shimmer and sparkles, but sadly those never photograph too well. The only exception to the shimmer or sparkle is the outer border of flowers, which is plain.
pop dots; shimmer cardstock: black, gray, and light yellow; patterned paper with flowers; card: A7 ivory shimmer; Spectrum Noir Clear Sparkle Pen; Tsukineko Pearlescent Sky Blue - Brilliance Pigment Ink; Colorbox Archival Dye in Wicked Black; Sizzex Big Kick; Scotch Advanced Tape Glider (ATG)
with Acid Free tape; embossing heat tool; cutting tool (I used my Silhouette but even an Exacto would work); and a MISTI
Cut the patterned paper to 5" by 7"; cut a rectangular hole in the middle half an inch from each side. You can use the inner rectangle to cut the banner strip of patterned paper. Cut the gray shimmer cardstock to 4" by 6", again with a rectangular hole in the center, leaving a thin border of shimmer gray. Cut some of the black shimmer cardstock to a 5" by 2" piece.
Stamp the butterfly with the blue ink and use the heat tool to dry. Die cut the butterfly. Stamp your choice of words on the banner strip of paper using the black ink, and trim the end to a fetching arrowhead. Swipe the banner strip with a sparkle pen.
Glue the patterned rectangle on your card first. Next glue the black rectangle, then the gray border. Add the banner strip to the top of these with pop dots, and use pop dots to adhere your butterfly. I seem to be addicted to using pop dots; I love the dimension they add to any piece!